Tender For auction sale of depot ferrous scrap - released mixed ferrous scrap: condemned spring, cut piece of axle, liner, piston, bearing ring, scrap bull gear, break disc, buffer plunger, face plate, screw and cbc coupler, scrap fork eye, break cylinder, schaku coupler axle box, buffer casing, nut bolt, pipe, rod, metal bin container, tray, stand and other mix miscellaneous ferrous scrap. excluding p.way items, steel and aluminium note : 1. re-punching with other lot will not be allowed. 2. loading will be start at 09.00 a.m. 3. loading will not be allowed after 15.00 hrs.
Tender For auction sale of depot ferrous scrap - released mixed ferrous scrap : condemned brake disc, scrap bull gear, buffer plunger, face plate, screw and cbc coupler, scrap fork eye, break cylinder, break disc. buffer casing, after cooler, housing pump, cylinder head, nut-bolt,liner, pipe , rod and other mix.miscellenous ferrous scrap.excluding steel and aluminium note : 1. re-punching with other lot will not be allowed. 2. loading will be start at 09.00 a.m. 3. loading will not be allowed after 15.00 hrs.
Tender For supply of horn & axle box face liner, thickness of liner required: 5 +/- 0.25 mm, remaining dimension and material specification as per rdso drg. no. skvl 058 . [ warranty period: 30 months after the date of delivery ]
Tender For corrigendum : supply of double end ctrb mounting machine for mounting the ctrb simultaneously from both ends of wheel set, cap. 70t. as per technical specification given below : (1) hydraulic power pack : double speedmaximum working pressure of 450 kg/cm2 pump, pcm, level gauge, breather, strainer and pressure gauge etc will be installed in the power pack. (2) piston stroke of the cylinder : 450 mm (minimum) (3) capacity of the machine : 70 ton(4) speed (i) advance (idle stroke) 800 mm/min (+/-10%) (ii) installation : 110 mm/min (+/- 10%) (5) type of cylinder :hydraulic double acting (6) jack adjusting height from rail level to centre of installation tube : 360 to 560 mm (7) type of wheel lifting jack : supporting guide jack system with machine frame. ( 8) bearing mounting final pressure : 50+/-tons (will be held for 05 seconds) (9) type of pressure gauge : marking of pressure gauge will be dial in parallel measured in tones and kg/cm2 (10) time of both side mounting of bearing : not more than 2.5 minutes. make : sumanglam. technical specification attached. at annexure a. [ warranty period: 30 months after the date of delivery ]
Tender For supply of cable speedometer,horn low,kit pad assy,assy arm wiper,tie rod steering,cable comp front brake,plate clutch,cable comp clutch,gasket cylinder head cover,assy cable complete,rectifire assy,regulator,rep kit air dryer assy,rep kit for wheel cyl,assy pipe,master cylinder repair kit,assy hose