Latest metering cubical scrap Tenders | Government metering cubical scrap Tenders

CTN :43941204

02 Mar, 2026 NA

Bhopal - Madhya Pradesh

Tender For supply of electrical and electronics laboratory setup - rlc resonance trainer kit series and parallel resonance, kit consists of voltmeter and frequency counter, inbuilt signal generator, experiments can be performed with or without oscilloscope inbuilt power supply, maximum power transfer theorem trainer kit maximum power transferred from a source to a load when the load resistance is made equal to the internal resistance of a source. inbuilt fixed dc regulated power supplies : 12vdc, meters, ammeter & voltmeter, required components provided, circuit diagram printed on front panel & all important test points are brought out on front panel power requirement : 230 vac, clamp on meter suitable for min 300 a ac/dc current measurement range: 0.2 to 300 a, accuracy 1.5% ac voltage: mv to 1000 vac, accuracy: 0.75% dc voltage: 30mv to 1000 vdc, accuracy: 0.5% resistance: upto 30 mohm, accuracy: 0.5% capacitance 1 nf to 30 micro f, accuracy: 1% frequency upto 100 khz, accuracy: 0.5% auto hold, max/min, auto/manual, diode, ip20 protection., digital meter: portable table top type, with cabinet and stand, terminals brought out for connections, range: voltmeter:0-750v ac 0-500 vdc, ammeter:0-20a ac 0-20a dc 2 nos each range, electronic energy meter( single phase) 240vac, 20aac, electronic energymeter( three phase) 400 vac, 30 aac, digital multimeter ¾ digit , true rms ac voltage range : 1 mv to 1000v, accuracy < 1% dc voltage range : 10 mv - 1000 v, accuracy < 0.5% ac current range : 1 ma-10a, accuracy < 2%, dc current range 0.01 ma-10a, accuracy < 1.5%, resistance: 100 mohm-60 mohms, accuracy < 0.5% input impedance: 10mohm capacitance: 1 nf – 60 mf, accuracy: < 5%, frequency: 0.01 hz – 10 khz, accuracy < 0.1% duty cycle, temperature and diode test, lcd display with auto / manual range , included accessories: test leads, rubber holster, temperature probe, battery charger 12 / 24v dc, 15 a, digital power factor meter, portable bench top type, with cabinet and stand, terminals brought out for connections, range: single phase, 220v ac, 5a, digital frequency meter, portable bench top type, with cabinet and stand, terminals brought out for connections, range: 45-55 hz, digital wattmeter, portable bench top type, with cabinet and stand, terminals brought out for connections, range: 220v, 5a ac single phase (2 nos) 400 v, 5a ac, three phase (2 nos), single phase half wave, full wave , fully controlled bridge rectifier / converter design to study to controlled rectifier & observe wave form on cro. meters provided of suitable range, in built power supply. load resistance, controls for phase angle. circuit diagram printed, & test points brought out on front panel. power requirement: 230 vac +10%, 50hz. supplied with patch chords & instruction manual, ups trainer kit input range: 170 to 270 v, ac output (input present): 195 to 250 v capacity: 200 w battery: 12 v / 7 ah, maintenance free, test points for experimentation purpose. panels: input / output / battery / transformer / avr / charger /inverter study of charger study of changeover logic study and working of ups, smps trainer kit input : 110- 230v, output : 12v dc, switching transformer, scr commuation trainer kit two dc regulated power supplies 0-30vdc/150ma & 0-1 vdc/150ma, three meters for voltage & current measurement , scr 2p4m mounted behind the panel, connections of supplies, meters & scr brought out at 4mm sockets., characteristics trainer kit for scr,diac,triac, ujt,igbt instrument comprises of three dc regulated power supplies 0-15 vdc/150ma, 0-50 vdc/150ma & 0-2.5 vdc/150ma, four round dual range meters for voltage & current measurement,ujt, scr, diac, triac & their supportive components mounted behind the panel, connections of supplies, meters & components brought out at 4mm sockets., kit for speed control of dc motor using microcontroller eters (digital) :0-200v dc, 0-500ma dc instrument provided with 1/12 hp dc motor, on board phase a

CTN :43961795

26 Feb, 2026 NA

Jabalpur - Madhya Pradesh

Tender For supply of melting point app manual with thermometer , ph meter digital with electrode , water bath 6 holes double walled electrical , variable micropipette , micropipette fixed , hall effect experiment complete setup , solar cell characteristics apparatus complete with all accessories , hot plate 8 round electrical , travelling microscope v h heavy pattern , bending of beam app , sodium vapour lamp complete set , charging discharging of capacitor , maxwells vibration needle , inertia table , compound bar pendulum brass strip , torsion pendulum 5 brass , callender and barnes continous flow , lee disc app , resolving power of telescope reading telescope , newtons law of cooling double pattern , spectrometer 6 , half shade polarimeter experiment setup , laser experimental set up he-ne laser , newtons ring experiment complete setup , resistance in series parallel apparatus with power supply , verification of network theorem four in one , half wave full wave bridge rectifier apparatus , energy band gap of pn junction diode apparatus with 2 digital meters , fet characteristics apparatus with regulated power suppli , transistor ch apparatus , plancks constant apparatus using solar cell , em by thomson method , pn junction diode ch app , zenor diode ch app , fly wheel with counter , ic regulated battery eliminator 3 amp , digital multimeter , spectrometer prism crown 32 mm , grating d 15000 lines , slide cabinet 1000 slides wooden , compound microscope isi mark with inbuilt led , dissecting microscope , binocular microscope with led isi mark , microscope camera 5 mp , trinocular research microscope led , rotary microtome , digital colony counter , centrifuge machine 3500 rpm , digital callorimeter , digital conductivity meter , harbarium cabinet 12 drawers , magnetic stirrer with hot plate , tlc kit with applicator , function generator 1hz to 200khz , digital electronic balance , water soil testing kit digital

CTN :43536119

10 Mar, 2026 NA

Gurdaspur - Punjab

Tender For corrigendum : supply of t and p material at rsd hydel project, shahpurkandi - digital multi-meter, clamp on meter, digital leakage clamp meter, earth resistance tester, portable dc resistance set, aluminum c shaped section 66x31.7mm as per is: 733-1983 temper t-06, portable air compressor, earth sticks for 220kv switchyard, chain saw cutter, hammer drill, cordless impact wrench, vacuum cleaner, air blower, temperature gun, safety helmets, safety belts

CTN :43668260

16 Feb, 2026 5.57 Lacs

Faridabad - Haryana

Tender For corrigendum : purchase of traning kits for emmi lab - emmi lab training kit of electrical and electronics engg. deptt., lcr meter specification as per tender notice, measurement of self inductance by maxwells bridge specification as per tender notice, linear variable differential transducer trainer specification as per tender notice, load cell demonstrator specification as per tender notice, temperature transducer trainer specification as per tender notice, measurement of strain using strain gauge specification as per tender notice, measurement of torque using strain gauge specification as per tender notice, measurement of capacitance by desautys bridge specification as per tender notice, measurement of self inductance by andersons bridge specification as per tender notice, measurement of self inductance by hays bridge specification as per tender notice, measurement of self inductance by owens bridge specification as per tender notice, measurement of capacitance by schering bridge specification as per tender notice, portable wheatstone bridge specification as per tender notice, measurement of low resistance by kelvins double bridge specification as per tender notice, osaw senior kelvin double bridge (s.k.d.b) 0.02 micro ohm to 1.1 ohm specification as per tender notice, spot reflecting galvanometer specification as per tender notice, adjustable heavy duty dc source 10a-15v specification as per tender notice, adjustable heavy duty dc source 25a-3v specification as per tender notice, calibrarion of l.p.f wattmeter by phantom loading specification as per tender notice, to study phase shifting transformer (3 phase) and its application in calibration of three phase energy meter specification as per tender notice

State Government

CTN :43905464

13 Feb, 2026 NA

Ghaziabad - Uttar Pradesh

Tender For supply of point machine and various other items as per boq attached inspection rdso rites consignee - supply of point machine irs type 220 mm stroke clamp type as per irs s$-24/2002 (amendment 1) or latest.(inspection agency:- rdso), supply of q-series led ecr (universal type i.e.qecx-61), 4f/4b complete with plug board(base plate), connectors, retaining clips etc. and conforming to brs: 941a sts / e / relays / ac lit led signal / 09 - 2002, amdt.-1 or latest and rdso spec.no.irs: s - 34, s- 23 or latest, as applicable. the interlocking code for this unit shall be "abdhk". (inspection by rdso)., contactor unit (qbca1 type), 24 v dc, 2hf / 4b complete with plug board (base plate), connectors, retaining clips etc and conforming to brs- 943 and rdso specn. no. irs : s - 34, s- 23, s - 60 or latest, as applicable. th e interlocking code for this unit shall be "bcejk". (inspection by rdso)., q-series magnetically latched neutral line relay (ql1 type), 11f / 4b, 24v dc complete with plug board (base plate), connectors and retaining clips and con forming to brs-935a and rdso specn. no.irs : s - 34, s - 23 or latest, as applicable. the interlocking code for this unit shall be "abdeg.(inspection by rdso)., supply of basic material to construct unit maintenance free earth as per rdso specs. no. rdso/spn/197 ver. 1.0 or latest to achieve a resistance less than 1 ohm. it consist of following:(a) copper bonded steel electrode of minimum 3.0 meter long, minimum 17.0 mm dia with copper bonding thickness of minimum 250 microns and ul listed and marked = 1 no. (b) earth enhancement material supplied in sealed bags of minimum 10 kg = 3 nos. (c) copper strip of 150x25x6 mm, to terminate earth rod = 1 no. (d) copper strip of 300x25x6 mm (meeb) = 1 no. (e) copper strip of 150x25x6mm (seeb) = 1 no. (ii) supply of 35 sq. mm multi strand single core pvc insulated copper cable as per is: 694 for connecting main earth electrode to meeb in the equipment room in duplicate. (minimum 10 meter.) (iii) supply of 16 sq. mm multi strand single core pvc insulated copper cable as per is: 694 for connecting meeb to seeb and spd to meeb (minimum 10 meter.) (iv) supply of 10 sq. mm multi strand single core pvc insulated copper cable as per is: 694 for connecting various equipments to seeb (v) supply of copper lug sleeve for 3/16 cable.(inspection by consignee)., supply of master telephone with voice logging facility for electronic lc gate telephone system as per specification no: rdso/spn/tc-51/2011 revision 3.0 with amendment no. 1 or latest. (inspection by rites)., electronic lc gate slave telephone system with voice recorder as per rdso specification no. rdso/spn/ tc/51/2021 revision 1.0 (inspection agency:- consignee), supply of centralized power supply system 24 volts dc power pack with 7ah mf battery for electronic lc gate telephone system as per rdso spec:- no. rdso / spn / tc / 51 / 2011 (rev. 3.0) amdt - 1 or latest.(inspection agency:- consignee), supply of optical power meter, type-b, as per tec spec. gr / opm - 01 / 03 feb. 2005 or latest. (make & model khushicom-k280) or similar branded make. (inspection by consignee)., supply and testing of optical laser light source of make- jdsu model- ols-35 or similar branded make.(inspection agency:- rites), supply of optical laser torch of reputed make. (make & model-proskit mt-7530) or similar branded make. (inspection agency: - consignee), supply of automatic fusion splicer for single mode optical fibre cable, along with accessories as per tec spec. tec/gr/tx/osm 001/04/sep-12 or latest of make superior/fujikura or similar. consignee shall approve the supply only after successful demonstration at site. (inspection agency:- rites), supply of otdr suitable for 1310/1550nm fiber with resolution of 60 cm, dynamic range of 314/29 db with all accessories for working on single mode optical fiber as per tec spec. tec/gr/tx/otd 001/05/sep-19 or latest, of reputed make like yokogawa/zdsu/viavi or similar. consig

Central Government And Public Sector

CTN :43850633

23 Feb, 2026 NA

Kalpakkam - Tamil Nadu

Tender For corrigendum : supply of digital earth resistance meter (q3) , insulation tester (q3)

Central Government/Public Sector

CTN :43583508

16 Feb, 2026 NA

Singrauli - Madhya Pradesh

Tender For corrigendum : supply of wdg resistance meter, 40a dc or higher_ schedule 1_ item_ 10_ m9406476006n_ 100269034

State Government

CTN :43929190

19 Feb, 2026 NA

Ambala - Haryana

Tender For supply of digital earth resistance meter (q3)

CTN :43865754

26 Feb, 2026 NA

Raigad - Maharashtra

Tender For supply of digital earth resistance meter (q3) , residual current device (rcd) or earth-leakage circuit breaker (elcb) tester (q3) , motor resistance and inductance measuring instrument (q3) , digital tachometer (q3) , digital light meter (q3) , non-contact high voltage detector (q3) , portable power analyzer, vfd, flex clamp , battery analyzer , installation tester w or rcd type b and ev , digital earth tester , milliamp clamp meter , insulation tester,1000v,ir , insulation tester,high volt , digital true rms ac or dc clamp meter