Latest pipe joint Tenders | Government pipe joint Tenders

Central Government/Public Sector

CTN :41710025

25 Sep, 2025 NA

Mumbai - Maharashtra

Tender For supply of thermoplastic textile reinforced water hose size: 31.5 mm x 15 mtrs. long to specn.is:12585-2023. type-2 [reinforcement synthetic textile cover 5 smooth finish] note: i] the water hose shall be warranted for a period of 18 months from the date of delivery at depot. ii] material should be flexible to insert in respective pipe joints and to tight hold the conventional worm drive clips to is: 4762-2002 reaffirmed-2021 or latest. iii] colour of water hose yellow/black. iv] manufacturer should be a bis registered source and indicate cm/l no. in the offer.

Central Government/Public Sector

CTN :41666756

22 Sep, 2025 44.00 Lacs

Mumbai - Maharashtra

Tender For repair/replacement of water supply distribution pipe, joints, repair to internal wiring, submain wiring, security light, control panel, high mast light and other connected electrical works at various pockets of af stn mumbai under ge(af)thane

CTN :41704765

15 Sep, 2025 1.30 Lacs

Kupwara - Jammu And Kashmir

Tender For supply of pipe joints , english seat cera , english seat pearl , pvc pipe , pvc pice

CTN :41642410

22 Sep, 2025 NA

Leh Ladakh - Jammu And Kashmir

Tender For supply of serving repairing of blockage choke in the hot water boilers of capacity 350000 kcal hr including repair of control panel , serving repairing of blockage choke in the hot water boilers of capacity 150000 kcal hr including repair of control panel , serving reparing of the coil unit in 128 men barrack ie motor re binding , providing and replacement of pipe joint seal , replacement of butterfly valve 100 mm , supply glycol unit existing central heating system as per approved specification and direction of engineering in , providing and replacment of ignition rod and direction of engineering in charge , replacemnt of 15 hp motor starter and direction of engineering in charge , providing and replacement of fule pump and direction of engineering in charge , providing and replacement of fule pipe and direction of engineering in charge , providing and replacement of fule filter and direction of engineering in charge , providing and replacement of buner nozzel and direction of engineering in charge , providing and replacement of photo cell and direction of engineering in charge , providing and replacement of sequence controller and direction of engineering in charge ) /bid number : gem/2025/b/6629716 * /dated: 31-08-2025 & & / bid document 1 / 17

Central Government/Public Sector

CTN :41652326

09 Sep, 2025 NA

Jalandhar - Punjab

Tender For supply of hydraulic filter , air brake connector male , air brake connector female , air bellow , bush jack , on off switch , fuel pipe , jointing sheet , stopper cable

Central Government/Public Sector

CTN :41674056

15 Sep, 2025 NA

Chennai - Tamil Nadu

Tender For supply of teflon tape for sealing threaded pipe joint screwed fitting 12mm width 0.1mm thick of 12 metres roll similar to champion teflon.

Central Government/Public Sector

CTN :41613074

22 Sep, 2025 NA

Noida - Uttar Pradesh

Tender For procurement of koel da rkit 26 and ard 25 - cgsd (mbi), air starter, da sea water pump / assembly of raw water pump, automatic voltage regulator,, dv electronic governor with over speed protection, set of joints, starting air pressure sensor, hp pipe assembly, speed control unit, temp sensor with inbuild transmitter (type-mbt5560,range 0-150d, outpu, limit switch, turbo oil drain pipe, double gear assembly, 0-2.5 bar danfoss make pressure transmitter for marine, pf33 individual pump, fuel pipe (from tank to feed pump tee) (marine-abs approved), set of o ring, exhaust temprature sensor with 2pin connector, fuel leakage switch, pump to leak off (marine abs approved), leakoff pipe (uniflex), piston assembly, fuel pipe (feed pump tee to filter in marine - abs approved), turning gear engaged limit switch, fuel pipe (from fuel filter to fip) (marine abs approved), centrifugal oil cleaner (band design), assly. rocker lever, oil filter element, k-coolant (26 lit can), small end bush (finished), belt v section (bx 58-pitchl ength 1520), hose reducer elbo, set of copper washers, fuel pipe (tee to pump inlet gear end) (marine abs approved), fuel pipe tee to feed pump gear end (marine abs approved), leak off pipe (from hp pipe to collector)marine _x0013_ abs approved, fuel pipe (tee to feed pump) (marine abs approved), belt for sea water pump drive, water level switch, thermostat element, hose for turbo compressor out, breather pipe, breather hose for marine, elbow connection, cly.head steel gasket 1.2 mm, bend 90 for feed pump out, top piston ring, exhaust valve, leakoff pipe for hp jacketed pipe (lh), drain cock, hose (dia 54) (bet.2 pipes), oil control ring, fuel pipe (tee to pump in), nozzle body (for oil spray nozzle), second ring piston, inlet valve, bolt (bearing cap), make up pipe, fuse terminal block 6a with 2a fuse link, exhaust valve seat insert, connecting rod bolt, rc joint, m.b.cross bolt (short), clamp(for fuel pipe), joint for governor mounting plate, special nut for exhaust manifold, valve seal, counter shunk head screw (for dv injector leakoff), valve guides, exhaust manifold stud, grommet: 22 dia ferrule, rubber bush (bottom), joint (bet.exh.manifold and expa. bellow), s.s.nut, sealing cap (for dia 25), valve collet, sealing cap (40 din 443)8, o ring: drain plug, grommet: 12 dia ferrule, stud-m10x1.5x25-8.8, set screw m8x1.25x25...8.8, washer copper, cup for valve springs, gasket (lub oil header), washer copper (18x22), plain machined washer - m6, service kit for heat exchanger, fuel feed pump, service kit for centrifugal filter, k cool super plus 50-50 premix 26 liter can, k-cool super plus, bearing, bearing, k sealent (80 ml), flat seal for oil seal housing, oil seal for drive end, conical copper washer, spring, cup for pr tube, flexible bellow, sea water outlet pipe from cac, joint for t connection, joint for sea water pump, joint for sea water piping, pipe for he raw water out, roller tappet assly, rubber sleeve, set bolt-m14x2x60-8.8, dowel pin, k cool plus 26 ltrs can, clamp (2 pipe), crank pulley, inlet valve seat semi-finish, exhaust valve seat semi- finish, cup washer (for nozzle clamp), valve guide, oil seal pulley end, timing pointer (for pulley), air shut off valve, set of main bearings, set of thrust washer, set of gasket for heat exchanger ts6m, oil pipe ( crankcase to pump), hose for air starter, sub assembly of bearing housing, joint cooler cover(rh)from fwe, k-coolant (26 ltrs can), copper washer (18x22), k-sealant, wire braided pipe from jacketed leakoff to fuel collector, temperature guage (0-120 deg), rubber bush (top), pressure guage (0-4 bar), pipe(sea water pump outlet to check valve), o-ring for drain plug, npt plug with zinc bar with he, k sealant 80 ml, drain cock, stud, set screw -m8x1.25x25-8.8, hose clip, copper washer, anti vibration mount - cori, anabond 666t max 25g, hose t bolt, hose clamp, rotary drain pump, k sealant (80 ml), automatic voltage regulator, worm drive hose clip (70mm), se

Central Government And Public Sector

CTN :41605067

11 Sep, 2025 NA

Sonitpur - Assam

Tender For supply of polyamide thread for pipe joint

Central Government/Public Sector

CTN :41541106

13 Sep, 2025 3.00 Lacs

Udaipur - Rajasthan

Tender For supply of health faucet set model f160023 , bottle trap 150mm , wc hinges left , right , drain jali plain 4inch round shape , caustic soda , spindle for autoclosing push tap koher model 20747in 8 cp , drain chemical powder , face plate cistern 525017 , soap dispenser ss 304 wall mounted 600 800ml , pvc socket 110mm , pvc tee 110mm , pvc elbow 75mm , pvc door tee 75mm , pvc pipe 75mm , cpvc brass mta 20 mm , cistern ball cock , connection pipe 18 inch ss braided , connection pipe 18 inch pvc , bomper washer 5 inch for wall hung wc , head shower 16356in a cp , pvc door bend 110mm , cpvc reducer 20x15mm , pillar cock , cistern trap assembly 1278615 , water storage tank 500 litre 3layer , washing machine inlet pipe semi automatic , urinal waste coupling porcelain , urinal waste coupling ss , urinal spreader , cpvc ball valve 100mm , brass wall mixer l bend with set , spindle for hindware piller cock , spindle set for hindware wall mixer right left and center , angle valve , scalefoe 100 , cpvc brass elbow 20x15 , cpvc brass threaded fta 40mm , cpvc brass threaded mta 40mm , brass forged ball valve 40mm , cpvc ball valve 32mm , washing machine inlet pipe automatic , washing machine outlet drain pipe , sink tap spindle , gi tee 15mm , gi dead plug 15mm outer thread , gi dead plug 20mm outer thread , gi dead plug 32mm outer thread , gi dead plug 40mm outer thread , brass gate valve 50mm , pvc pipe 6 inch 06 08 kg pressure , health faucet connection pipe ss braided , hdpe pipe joint couplesize 63mm , polycarbonate fabrication panel sheet size 20 x 3feet

CTN :41557279

18 Sep, 2025 NA

Ayodhya - Uttar Pradesh

Tender For dismantling & repairing of v.t pump 150 cusec pump no 4 after removing h.t. motors then opening pump coupling, motor stool, driving coupling thrust bearing delivery pipe joints & lifting column pipe shafts tubes rubber bearing spiders sleeves etc. all component up to bell mouth of pump, muff coupling of stainless steel material as per original sample for jointing intermediate shaft, impeller of pump by opening & taking out all the twisted and rubbed vanes, straightening the twisted vanes and welding on rubbed portion by high quality s.s. welding electrodes & grinding etc. for giving it, it is original shape and size fitting vanes in impeller body using new lock washers balancing the impeller complete on precision machines its cartage from site to suitable work shop and back.,ratchet pin housing with cutting rubbed portion welding with c.i. welding rod with proper method, then machining from different angle on precision machine to bring it proper shape & size, neck ring assembly of pump by casting, moulding, turning, finishing to proper size as per specification/sample including cost of all materials, labour, casting forma making including carriage of job sample from site to suitable workshop and back.and erection & commissioning of repaired pump with column pipe, housing pipe, impeller shaft, bowl assembly, spider etc. including assembling of pump by repairing all repaired neck ring, rubber bearing etc. and erecting all above parts of pump in the suction sump including all t&p, labour etc. at ayodhya pump canal vikramjot vasti

Pipe Joint Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government And Public Sector

Central Government/Public Sector