Latest pipe joint Tenders | Government pipe joint Tenders

Central Government/Public Sector

CTN :41710025

25 Sep, 2025 NA

Mumbai - Maharashtra

Tender For supply of thermoplastic textile reinforced water hose size: 31.5 mm x 15 mtrs. long to specn.is:12585-2023. type-2 [reinforcement synthetic textile cover 5 smooth finish] note: i] the water hose shall be warranted for a period of 18 months from the date of delivery at depot. ii] material should be flexible to insert in respective pipe joints and to tight hold the conventional worm drive clips to is: 4762-2002 reaffirmed-2021 or latest. iii] colour of water hose yellow/black. iv] manufacturer should be a bis registered source and indicate cm/l no. in the offer.

Central Government/Public Sector

CTN :41666756

22 Sep, 2025 44.00 Lacs

Mumbai - Maharashtra

Tender For repair/replacement of water supply distribution pipe, joints, repair to internal wiring, submain wiring, security light, control panel, high mast light and other connected electrical works at various pockets of af stn mumbai under ge(af)thane

CTN :41704765

15 Sep, 2025 1.30 Lacs

Kupwara - Jammu And Kashmir

Tender For supply of pipe joints , english seat cera , english seat pearl , pvc pipe , pvc pice

CTN :41642410

22 Sep, 2025 NA

Leh Ladakh - Jammu And Kashmir

Tender For supply of serving repairing of blockage choke in the hot water boilers of capacity 350000 kcal hr including repair of control panel , serving repairing of blockage choke in the hot water boilers of capacity 150000 kcal hr including repair of control panel , serving reparing of the coil unit in 128 men barrack ie motor re binding , providing and replacement of pipe joint seal , replacement of butterfly valve 100 mm , supply glycol unit existing central heating system as per approved specification and direction of engineering in , providing and replacment of ignition rod and direction of engineering in charge , replacemnt of 15 hp motor starter and direction of engineering in charge , providing and replacement of fule pump and direction of engineering in charge , providing and replacement of fule pipe and direction of engineering in charge , providing and replacement of fule filter and direction of engineering in charge , providing and replacement of buner nozzel and direction of engineering in charge , providing and replacement of photo cell and direction of engineering in charge , providing and replacement of sequence controller and direction of engineering in charge ) /bid number : gem/2025/b/6629716 * /dated: 31-08-2025 & & / bid document 1 / 17

Central Government/Public Sector

CTN :41652326

09 Sep, 2025 NA

Jalandhar - Punjab

Tender For supply of hydraulic filter , air brake connector male , air brake connector female , air bellow , bush jack , on off switch , fuel pipe , jointing sheet , stopper cable

CTN :41638610

08 Sep, 2025 NA

Mumbai - Maharashtra

Tender For tender for supply of procurement of various spares undertake eamp 25 of ins trishul d d - holding band , guide bush , flolower/ sleeve , muffler assembly , diffuser , o ring , recoil assembly , barrel & plunger , connecting rod bearings , spacer , mounting , starter 12v , alternator , connecting rod bearings , pump assembly injection , seal , o ring , micro console card , control transformer , hp pump crank case oil , high pressure pump , pulley 5 grove spa 122 , adapter , male , seal , oil , crankshaft , seal , oil , crankcase , oil drain kit , sleeve gasket , victualic coupling 1 , high pressure trans , ele , spare kit , temperature indicator , sensor cable with electrode , seal ring , charging screw , a/v mount for hp pp trolley , neck ring p45 , victaulic couplers , o ring for head distributor , filter element , o ring cartridge filter housing , dolomite , pressure switch , hp connection feed/brine , rubber hose from cf outlet , ss jubilee clips 2x (45mm to 60mm) , jubilee clip , 2a (38mm-50mm) , lp hose 32mm id bare hose , pu9 pipe , pl4 pipe , connector straight , 1/4 fxu4 elbow , abs service kit , hp hose module out , hp hose raw water/ brine 2500l , coupler for vict coup 1 , hp elbow 1 for smcv , st. connector 1smcv , pressure gauge (0-10 bar)

Central Government/Public Sector

CTN :41613074

22 Sep, 2025 NA

Noida - Uttar Pradesh

Tender For procurement of koel da rkit 26 and ard 25 - cgsd (mbi), air starter, da sea water pump / assembly of raw water pump, automatic voltage regulator,, dv electronic governor with over speed protection, set of joints, starting air pressure sensor, hp pipe assembly, speed control unit, temp sensor with inbuild transmitter (type-mbt5560,range 0-150d, outpu, limit switch, turbo oil drain pipe, double gear assembly, 0-2.5 bar danfoss make pressure transmitter for marine, pf33 individual pump, fuel pipe (from tank to feed pump tee) (marine-abs approved), set of o ring, exhaust temprature sensor with 2pin connector, fuel leakage switch, pump to leak off (marine abs approved), leakoff pipe (uniflex), piston assembly, fuel pipe (feed pump tee to filter in marine - abs approved), turning gear engaged limit switch, fuel pipe (from fuel filter to fip) (marine abs approved), centrifugal oil cleaner (band design), assly. rocker lever, oil filter element, k-coolant (26 lit can), small end bush (finished), belt v section (bx 58-pitchl ength 1520), hose reducer elbo, set of copper washers, fuel pipe (tee to pump inlet gear end) (marine abs approved), fuel pipe tee to feed pump gear end (marine abs approved), leak off pipe (from hp pipe to collector)marine _x0013_ abs approved, fuel pipe (tee to feed pump) (marine abs approved), belt for sea water pump drive, water level switch, thermostat element, hose for turbo compressor out, breather pipe, breather hose for marine, elbow connection, cly.head steel gasket 1.2 mm, bend 90 for feed pump out, top piston ring, exhaust valve, leakoff pipe for hp jacketed pipe (lh), drain cock, hose (dia 54) (bet.2 pipes), oil control ring, fuel pipe (tee to pump in), nozzle body (for oil spray nozzle), second ring piston, inlet valve, bolt (bearing cap), make up pipe, fuse terminal block 6a with 2a fuse link, exhaust valve seat insert, connecting rod bolt, rc joint, m.b.cross bolt (short), clamp(for fuel pipe), joint for governor mounting plate, special nut for exhaust manifold, valve seal, counter shunk head screw (for dv injector leakoff), valve guides, exhaust manifold stud, grommet: 22 dia ferrule, rubber bush (bottom), joint (bet.exh.manifold and expa. bellow), s.s.nut, sealing cap (for dia 25), valve collet, sealing cap (40 din 443)8, o ring: drain plug, grommet: 12 dia ferrule, stud-m10x1.5x25-8.8, set screw m8x1.25x25...8.8, washer copper, cup for valve springs, gasket (lub oil header), washer copper (18x22), plain machined washer - m6, service kit for heat exchanger, fuel feed pump, service kit for centrifugal filter, k cool super plus 50-50 premix 26 liter can, k-cool super plus, bearing, bearing, k sealent (80 ml), flat seal for oil seal housing, oil seal for drive end, conical copper washer, spring, cup for pr tube, flexible bellow, sea water outlet pipe from cac, joint for t connection, joint for sea water pump, joint for sea water piping, pipe for he raw water out, roller tappet assly, rubber sleeve, set bolt-m14x2x60-8.8, dowel pin, k cool plus 26 ltrs can, clamp (2 pipe), crank pulley, inlet valve seat semi-finish, exhaust valve seat semi- finish, cup washer (for nozzle clamp), valve guide, oil seal pulley end, timing pointer (for pulley), air shut off valve, set of main bearings, set of thrust washer, set of gasket for heat exchanger ts6m, oil pipe ( crankcase to pump), hose for air starter, sub assembly of bearing housing, joint cooler cover(rh)from fwe, k-coolant (26 ltrs can), copper washer (18x22), k-sealant, wire braided pipe from jacketed leakoff to fuel collector, temperature guage (0-120 deg), rubber bush (top), pressure guage (0-4 bar), pipe(sea water pump outlet to check valve), o-ring for drain plug, npt plug with zinc bar with he, k sealant 80 ml, drain cock, stud, set screw -m8x1.25x25-8.8, hose clip, copper washer, anti vibration mount - cori, anabond 666t max 25g, hose t bolt, hose clamp, rotary drain pump, k sealant (80 ml), automatic voltage regulator, worm drive hose clip (70mm), se

Central Government/Public Sector

CTN :41674056

15 Sep, 2025 NA

Chennai - Tamil Nadu

Tender For supply of teflon tape for sealing threaded pipe joint screwed fitting 12mm width 0.1mm thick of 12 metres roll similar to champion teflon.

Central Government And Public Sector

CTN :41605067

11 Sep, 2025 NA

Sonitpur - Assam

Tender For supply of polyamide thread for pipe joint

State Government

CTN :41192212

04 Sep, 2025 17.01 Lacs

Anuppur - Madhya Pradesh

Tender For corrigendum : procurement of various spares of air pre heater (model 27vitm2000) of 210 mw, atps, mppgcl chachai - hot end air sealing housing assembly alongwith aluminum seal assy and fasteners , hot end tracking spool assembly alongwith adjuster rods , aluminum straight edge for radial seal setting , cold end spool assembly , pin and rack assembly , "water washing pipe assembly with ss nozzledia 114.3mm ,thickness 5.4mm, length 5090mm" , kao-wool packing (1"x 2 ft x 25 ft) , tapper lock bush & adapter (alloy steel) , "pressure relif valve 20mm for los working pressure 5kg/cm2make- corona or equivalent" , 50 mm gun metal valve thread connection for los working pressure 5kg/cm2 , hot end air sealing housing assembly alongwith aluminum seal assy and fasteners , hot end tracking spool assembly alongwith adjuster rods , aluminum straight edge for radial seal setting , cold end spool assembly , pin and rack assembly , 25 mm gun metal valve thread connection for los working pressure 5kg/cm2

Pipe Joint Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government And Public Sector

State Government