Latest tuner Tenders | Government tuner Tenders

CTN :45484029

19 Jun, 2026 NA

Doda - Jammu And Kashmir

Tender For supply of multicopter frame 13 inch fpv dropping drone , electronically commutated motors pmsm , motor controller inverter , wireless tuner superheterodyne , stm 32 bit microcontroller development board , radio controller , receiver display unit , battery 15000 mah lipo , battery charger , thrust generator blade assembly , ground contact struts , camera 1600 tvl fpv camera , gps module m10 series , extended antennas for drone and goggles , hard case for fpv drone transport and storage , payload delivery mechanism , vtx vrx , servo motor , cells for rc

Central Government/Public Sector

CTN :45463480

29 Jun, 2026 71.2 Thousand

Parganas - West Bengal

Tender For procurement of my choice make archery equipment for ncoe kolkata - archery items :, paper tuner, bow press

Central Government/Public Sector

CTN :45458906

17 Jun, 2026 NA

Bhusawal - Maharashtra

Tender For auction sale of depot non ferrous scrap - scrap condemned control cable (single & multi core) various types of different length or diameter with rubber and pvc insulation with or without lug if any released from electric locomotives (note-valid cpcb certificate is required)

Central Government/Public Sector

CTN :45458907

17 Jun, 2026 NA

Bhusawal - Maharashtra

Tender For auction sale of depot non ferrous scrap - scrap condemned released single core power cable of different dia and length covered with pvc insulation, attachment without copper lug if any released from electric loco. (note-: valid cpcb certificate is required.)

CTN :45432717

15 Jun, 2026 NA

Doda - Jammu And Kashmir

Tender For supply of multicopter frame 13 inch fpv dropping drone , electronically commutated motors pmsm , motor controller inverter , wireless tuner superheterodyne , stm 32 bit microcontroller development board , battery 15000 mah lipo , thrust generator blade assembly , ground contact struts , camera 1600 tvl fpv camera , gps module m10 series , extended antennas for drone and goggles , payload delivery mechanism , vtx vrx , servo motor , cells for rc

Central Government/Public Sector

CTN :45431068

11 Jun, 2026 NA

Kota - Rajasthan

Tender For auction sale of depot non ferrous scrap - 98210129scrap various type of copper items with ferrous attachment consistingof copper choke coil, copper coil, contactor coil and brake coil, srvalve set coil, bare coil wires, h.t. ct & pt mix all type with insulatingmaterial, copper c.p. pipes, copper contect tip, tinned copper terminalends/lug, geyser element, copper tube engine radiator attach withbrass frame,core after cooler cummins and other miscellaneous loco parts andother copper items & parts of sorts and sizes.

Central Government And Public Sector

CTN :45415104

10 Jun, 2026 NA

Varanasi - Uttar Pradesh

Tender For auction sale of depot non ferrous scrap - scrap cut pieces of single core thick copper cable of sort & sizes with or without lug . weight is in approx . note:- for purchase of this item central/state pollution control board certificate required. photograph available on ireps . note -1 : purchaser to submit power of attorney (poa) in uploaded format on ireps portal (purchaser can reach the said poa format in ireps through " document -> view & publish depot condition -> click for blw /gsd dlw document list -> action (view condition) ") note-2: in case of lot is sold ,in this auction purchaser needs to apply for delivery program in online mode through "manage delivery request " tab available on home screen of ireps portal

CTN :45404144

09 Jun, 2026 NA

Palacode - Tamil Nadu

Tender For supply of equipment for electronics and communication engineering department - supply of equipment for electronics and cmmunication engineering department, 8051 micro controller kit :specification : operating voltage: +5 v dc. flash memory: 4 kb (at89c51) / 8 kb (at89s52). ram: 128 bytes internal ram. 16 2 alphanumeric lcd display. push buttons / tactile switches. dip switches for digital input. inbuilt adc interface: ldr, potentiometer. inbuilt dac interface. inbuilt stepper motor driver with stepper motor. inbuilt dc motor driver with dc motor. 1 4 led array, 1 4 keypad, 1 relay. 1 buzzer, 16 2 lcd display, 1 pwm driver. 1 hardware interrupt key, inbuilt rtc. inbuilt eeprom and uart module. 4 7-segment display. supports both assembly and c language programming. pc interfaceable., temperaturemeasurementkitspecification : sensors:rtd (pt-100), thermocouple (fe-k/j-type), and/orthermistor (ntc). display: 3 digit led/lcd digital display(typically 200 mv fsd). temperature source: portable water kettle orheater block. signal conditioning: on-board circuitry foramplification, linearization, and cold junctioncompensation. test points: multiple 2 mm / 4 mm banana socketsfor monitoring input/output signals. power supply: 230 v ac, 50 hz, single-phase. accessories: glass thermometer, 10 k ntcthermistor probe, k-type thermocouple probe,patch cords and user manual., ask modulationanddemodulation kit:specification : message signal1:8-bit variable data,amplitude 5v. message signal 2:debounced data, amplitude low (0) and high (5 v). message signal 3:fixed data 25 khz, 12.5 khz, 6.25 khz, 3.12 khz,amplitude 5 v. carrier signal: sine wave, frequency 200 khz,amplitude 5 v. modulator type: switching modulator using analogswitch / transistor switching ic. demodulator: envelope detector and lpf. comparator: lm311 based. supply voltage (board): +12 v, +5 v dc. supply current: 100 ma minimum. input voltage: 230 v ac, 50 hz. interface connectors: 2 mm banana socket., dth trainer kit:specification :power supply: 200 v to 240 v ac, 50 hz.dish antenna: 1.5 ft aluminium steerable dish antenna.lnb (low noise block down converter): input frequency: ku-band. output frequency: 950 mhz to 1450 mhz. conversion gain: 65 db. noise temperature: 35 k (max).set-top box receiver in trainer form: if frequency: 70 mhz. video bandwidth: 50 hz to 5 mhz. video output level: 1 vpp at 75 load. video polarity: normal/inverted, switch selectable. audio subcarrier frequency:tunable from 5.0 mhz to 8.0 mhz. remote control provided. hdmi cable: 10 m.controls: channel selection. volume control.fault simulation: five built-in simulated faults for troubleshootingexperiments. if signal disconnected. video output fault. audio mute fault. tuner misalignment. rf output interruption.pcb size: 15" 12" with multicolour section-wise blockdiagram.standard accessories: 1.5 ft dish antenna. lnb. trainer pcb. dish connecting wire. audio-video cable. user manual. acrylic cover. hardware materials for assembly of dish antenna.additional features: dth subscription connection withdoordarshanfree channels. free-to-air channel demonstration., fpga trainer kit:specification : must use industry-standard mid-range fpgadevice usb-jtag programmable, compatible withvivado ise (webpack). power supply: 5 v dc through usb or externaladapter. on-board peripherals: leds, switches, pushbuttons, 7-segment display,clock source, gpio /pmod expansion ports, uart, vga / hdmi, usbuartbridge, usb cable. user manual.

Central Government/Public Sector

CTN :45383975

10 Jun, 2026 NA

Multi City - Maharashtra

Tender For auction sale of depot non ferrous scrap - scrap condemned released mixed aluminium cable various sizes and cores with minor lug attachment consisting insulation, pvc armoured. weight compositionaluminium=6484.44 kgpvc-1914.40= kgsarmour/gi-490.16 kgtotal wt=8889.00 kg

CTN :45379134

10 Jun, 2026 NA

Arakandanallur - Tamil Nadu

Tender For for electrical and communication engineering department lab equipments are required as per new syllabus - upgradation of labarotariesece department, 8051 micro controller kit operating voltage: +5 v dc. flash memory: 4 kb (at89c51) / 8 kb (at89s52). ram: 128 bytes internal ram. 16 2 alphanumeric lcd display. push buttons / tactile switches. dip switches for digital input. inbuilt adc interface: ldr, potentiometer. inbuilt dac interface. inbuilt stepper motor driver with stepper motor. inbuilt dc motor driver with dc motor. 1 4 led array, 1 4 keypad, 1 relay. 1 buzzer, 16 2 lcd display, 1 pwm driver. 1 hardware interrupt key, inbuilt rtc. inbuilt eeprom and uart module. 4 7-segment display. supports both assembly and c language programming. pc interfaceable., single phase induction motor1 hp, 230 v ac, 1500 rpm with loading arrangement 1 no.voltmeter: (0 300) v ac, 96 96 mm with input terminals 1 no.ammeter: (0 10) a ac, 96 96 mm with input terminals 1 no.wattmeter: 2 kw, 96 96 mm with input terminals 1 no.power factor meter: 96 96 mm with input terminals 1 no.auto transformer: 0 300 v, 1 variac 1 no.mcb: 2-pole, 40 a / 230 v ac 1 no.digital rpm indicator with proximity sensor 1 no.aluminium brake drum: 230 mm diameter 1 no.spring balance: (0 25) kg 02 nos.circuit diagram printed on front panel with instruments and connecting terminals.motor and loading arrangement mounted on rigidchannel frame with anti-vibration mounting pads, m12 1.5 bolt & nut, 85 mm dia 4 nos.mild steel powder-coated electrical panel tablesetup., auto transformerinput: 230 240 v ac, 50 hz.output: variable (0 270) v ac.rating: 1 kva.insulation class: class f / class h.construction: copper winding with carbon brush arrangement.mounting: bench-top / panel type.protection: suitable fuse / overload protection., dth trainer kitpower supply: 200 v to 240 v ac, 50 hz. dish antenna: 1.5 ft aluminium steerable dish antenna.lnb (low noise block down converter): input frequency: ku-band. output frequency: 950 mhz to 1450 mhz. conversion gain: 65 db. noise temperature: 35 k (max).set-top box receiver in trainer form: if frequency: 70 mhz. video bandwidth: 50 hz to 5 mhz. video output level: 1 vpp at 75 load. video polarity: normal/inverted, switch selectable. audio subcarrier frequency:tunable from 5.0 mhz to 8.0 mhz. remote control provided. hdmi cable: 10 m. controls: channel selection. volume control. fault simulation: five built-in simulated faults for troubleshooting experiments. if signal disconnected. video output fault. audio mute fault. tuner misalignment. rf output interruption. pcb size: 15" 12" with multicolour section-wise block diagram.standard accessories: 1.5 ft dish antenna. lnb. trainer pcb. dish connecting wire. audio-video cable. user manual. acrylic cover. hardware materials for assembly of dish antenna. additional features: dth subscription connection with doordarshanfree channels., sim reader trainer kitpower supply: operates on 230 v ac 10%, 50 hz mains supply. built-in regulated smps power supply. operating dc supply: 5 v / 12 v with overload and short-circuit protection.sim card interface: supports gsm sim cards compatible with 2g / 3g / 4g / 5g networks. sim card read/write interface. supports sim card initialization, authentication, and communication functions. compatible with standard 6-pin / 8-pin sim card sockets.communication interface: usb 2.0 interface for pc communication. rs-232 serial communication interface. uart communication facility for embedded system interfacing.sim operating parameters: selectable sim clock frequencies: 3.579 mhz 7.159 mhz 14.318 mhz sim supply voltage selection facility. sim reset and activation control. supported protocols and standards: gsm etsi 07.07 and etsi 07.05 at command support. iso/iec 7816 smart card communication support. sim communication command monitoring facility. hardware features: on-board sim card socket. led indication for: power status sim detection reset activity data transmission/r

Tuner Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government And Public Sector

Central Government/Public Sector